What are the precautions for using ultrafine grinder?
1.Check before operation
2.Material preparation
3.Operation process
4.Safety protection
5.Daily maintenance
6.Cleaning and Storage
7.Regular inspection
8.Emergency handling
1.Check before operation:
Ensure that there are no foreign bodies or debris in the equipment.
Check that all fastening screws are loose to ensure that rotating parts and silos are securely installed.
Check whether the electrical circuit is damaged and ensure that the power supply voltage meets the device requirements.
2.Material preparation:
The material should be kept dry and the moisture content should be less than 12%.
The particle size of the material should be less than 1cm, to avoid hard or too large materials into the equipment.
If the material is sticky, it is recommended to dry it.
3.Operation process:
When starting the equipment, it should run no-load first, and then gradually add materials after the equipment is running normally.
The feeding should be uniform to avoid excessive feeding resulting in motor overload.
Do not touch rotating parts or cleaning equipment while the equipment is running.
4.Safety protection:
Operators should wear protective equipment such as goggles, gloves, and masks.
Make sure the equipment is installed on a solid cement base and keep the operating area dry.
Equipment maintenance and maintenance
5.Daily maintenance:
Check whether the filter dust removal device is blocked every week, and clean the coated dust removal bag.
Regularly check the wear of wearing parts (such as hammer, gear ring, wear plate, etc.), and replace it in time.
6.Cleaning and Storage:
After each use, the inside of the equipment should be cleaned to avoid material residue.
After use, turn off the device and unplug it.
7.Regular inspection:
Check the lubrication system of the equipment regularly to ensure that the bearing and other parts are well lubricated.
Check that the protective devices of the equipment are in good condition to ensure safety.
8.Emergency handling
If abnormal sounds or faults occur during the operation of the equipment, stop the machine immediately for inspection.
In the event of an emergency such as fire or explosion, stay calm, quickly cut off the power supply and take emergency measures.
Strict compliance with the above precautions can effectively extend the service life of the ultrafine mill and ensure the safety of the operation process.